Digital Test Mode - Saeco Syntia Service Manual

SYNTIA
5.1.

Digital test mode

pos.
lev.
knob
L0
FIRMWARE
PRESS THE ON/OFF KEY TO ACCESS THE NEXT LEVEL UP
L1
KEYBOARD
KEYBOARD
KEYBOARD
KEYBOARD
PRESS THE ON/OFF KEY TO ACCESS THE NEXT LEVEL UP
Saeco International Group
display key
00.02.00
1 2 3 4
N N N N
1 2 3 4
Y N N N
1 2 3 4
N Y N N
1 2 3 4
N N Y N
To enter Test Mode
1. place the control knob in the water position
2. keep the espresso coffee key pressed
3. switch the appliance on from the 0/I button
located at the rear of it
4. release the espresso coffee key
function
View software
version
Initial condition with no keys pressed
no. 1 from " N to
Y " and display
from green
change to red
no. 2 from "N to
Y" and display
from green
change to orange
no. 3 from "N to
Y" and display
remains green
Rev.01 February 2010
05 SERVICE MODE
notes
The software version must be
the same as that stated on the
MicroProcessor plate
If display does not change and
remains as initial condition, replace
interface card and/or flat cable
JP21. If the colour of the display
remains green,
check JP4 wiring from interface
card to display
If display does not change and
remains as initial condition, replace
interface card and/or flat cable
JP21.
Page 1 / 07