Waterco Turbotemp 200HD Installation And Operation Manual page 9

Label all wires prior to disconnection when servicing controls. Wiring
!
CAUTION
errors can cause improper and dangerous operation. Wiring errors can
also destroy the control board.
• Connect heater to 240 Volt, 50 Hz., Single Phase power only.
• Verify proper operation after servicing.
• Do not allow children to play on or around heater or associated equipment.
• Never allow children to use the pool or spa without adult supervision.
• Read and follow other safety information contained in this manual prior to
GENERAL SPECIFICATIONS
NOTICE:
• Combustion air contaminated by corrosive chemical fumes can damage the heater and will
void the warranty.
• The Combination Gas Control Valve on this heater differs from most appliance gas controls.
If it must be replaced, for safety reasons replace it only with an identical gas control.
• The access door panels must be in place to provide proper ventilation. Do not operate the
heater for more than five (5) minutes with the access door panels removed.
• This heater is design certified by IAPMO as complying with the Standard for Gas Fired Pool
Heaters, and is intended for use in heating fresh water swimming pools or spas.
• The heater is designed for the heating of chlorine, bromine or salt system swimming pools
and spas. It should NOT be used as a space heating boiler, or general purpose water heater.
The heater requires an external 240 VAC single-phase electric power source.
• The heater should be located in an area where leakage of the heater or connections will not
result in damage to the area adjacent to the heater or to the structure. When such locations
cannot be avoided, it is recommended that a suitable drain pan, adequately drained, be
installed under the heater. The pan must not restrict air flow.
• The heater may not be installed within 3.5M (11.5 ft.) of the inside surface of a pool or spa
unless it is separated by a solid fence, wall or other permanent barrier.
operating this pool heater.
Section 2. Introduction I pg 08