Section 4. Operation; Basic System Operation / Hsi - Waterco Turbotemp 200HD Installation And Operation Manual

OPERATION INSTRUCTIONS
BASIC SYSTEM OPERATION
Start pump, make sure the pump is running and is primed, to close the water pressure
switch and supply power to heater. Be sure the pool and/or spa is properly filled with water.
Follow the Lighting/Operating instructions below.
TURBOTEMP HSI ELECTRONIC IGNITION LIGHTING/OPERATION
FOR YOUR SAFETY: READ BEFORE LIGHTING
!
WARNING
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
Do not attempt to light the heater if you suspect a gas leak. Lighting the
heater can result in a fire or explosion which can cause personal injury,
death, and property damage.
START-UP AND OPERATION
START-UP AND SHUTDOWN INSTRUCTIONS ARE ON THE LABEL ATTACHED TO THE
COVER OF THE APPLIANCE CONTROL BOX.
BEFORE START-UP
A. This appliance does not have a pilot. It is equipped with an ignition device which automatically
lights the burners. Do not try to light the burners by hand.
B. BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
– Do not try to light any appliance.
– Do not touch any electrical switch; do not use any phone in your building.
– Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
– If you cannot reach your gas supplier, call the Fire Department.
C. Use only your hand to turn the gas control on or off. Never use tools. If you cannot change
the ON/OFF setting by hand, don't try to repair it, call a qualified service technician. Forced
or attempted repair may result in a fire or explosion.
D. Do not use this heater if any part has been under water. Immediately call a qualified service
technician to inspect the heater and to replace any part of the control system and any gas
control which has been under water.
E. Do not operate the pool heater unless the pool or spa is properly filled with water.

Section 4. Operation

I pg 36