Section 2. Introduction; Important Notices - Waterco Turbotemp 200HD Installation And Operation Manual

INTRODUCTION
Turbotemp (Australia) Pool and Spa Heater
Congratulations on your purchase of a Turbotemp high performance heating system. Proper
installation and service of your new heating system and correct chemical maintenance of
the water will ensure years of enjoyment. The Turbotemp is a compact, lightweight, efficient,
induced-draft, gas fired high performance pool and spa heater that can be directly connected
to schedule 40 PVC pipe. The Turbotemp also comes equipped with the Pentair Water Pool and
Spa® multifunction temperature controller which shows, at a glance, the proper functioning of
the heater. All Turbotemp heaters are designed with a direct ignition device, HSI (hot-surface
ignition), which eliminates the need for a standing pilot. The Turbotemp requires an external
power source (240 VAC 50 Hz) to operate.
SPECIAL INSTRUCTIONS TO OWNER: Retain this manual for future reference. This instruction
manual provides operating instructions, installation and service information for the Turbotemp
high performance heater. The information in this manual applies to all Turbotemp models. READ
AND REVIEW THIS MANUAL COMPLETELY, it is very important that the owner/installer read
and understand the section covering installation instructions, and recognize the local and state
codes before installing the Turbotemp. Its use will reduce service calls and chance of injury
and will lengthen product life. History and experience has shown that most heater damage is
caused by improper installation practices.

IMPORTANT NOTICES

THIS PRODUCT MUST BE INSTALLED AND SERVICED BY A PROFESSIONAL SERVICE
TECHNICIAN, QUALIFIED IN POOL HEATER INSTALLATION.
For the installer and operator of the Turbotemp pool and spa heater: The manufacturer's
warranty may be void if, for any reason, the heater is improperly installed and/or operated. Be
sure to follow the instructions set forth in this manual. If you need more information or if you
have any questions regarding to this pool heater, please contact.
Waterco Limited - Offices Australia
NSW - Sydney (HEAD OFFICE)
Tel : +61 2 9898 8686
QLD - Brisbane
Tel : +61 7 3299 9900
VIC/ TAS - Melbourne
Tel : +61 3 9764 1211
SA/ NT - Adelaide
Tel : +61 8 8244 6000
WA - Perth
Tel : +61 8 9273 1900
Waterco (NZ) Limited
Auckland, New Zealand
Tel : +64 9 525 7570