Warranty Information; Code Requirements - Waterco Turbotemp 200HD Installation And Operation Manual

WARRANTY INFORMATION

The Turbotemp pool heater is sold with a limited factory warranty. Specific details are described
in the Waterco Warranty Terms and Conditions booklet included with the product.
Waterco pool and spa's high standards of excellence include a policy of continuous product
improvement resulting in your state-of-the-art heater. We reserve the right to make improvements
which change the specifications of the heater without incurring an obligation to update the
current heater equipment.
These heaters are designed for the heating of chlorine, bromine or salt system swimming
pools and spas or in non-stationary installations, and should never be employed for use
as space heating boilers or general purpose water heaters. The manufacturer's warranty
may be void if, for any reason, the heater is improperly installed and/or operated. Be sure
to follow the instructions set forth in this manual.
!
CAUTION
OPERATING THIS HEATER CONTINUOUSLY AT WATER TEMPERATURE BELOW 20°C.
WILL CAUSE HARMFUL CONDENSATION AND WILL DAMAGE THE HEATER AND VOID
THE WARRANTY. Do not use the heater to protect pools or spas from freezing if the
final maintenance temperature desired is below 20°C., as this will cause condensation
related problems.

CODE REQUIREMENTS

Installation must be in accordance with the following:
• Manufacturer's Installation Instructions
• AS/NZS 5601.1 for Gas Installations
• Local Gas Fitting Regulations,
• Municipal Building Codes,
• S.A.A. Wiring Code,
• Local Electrical Regulations
• Any other statutory regulations
!
DANGER
CARBON MONOXIDE GAS IS DEADLY – Exhaust from this pool heater contains toxic
levels of carbon monoxide, a dangerous, poisonous gas you cannot see or smell.
Section 2. Introduction I pg 04