Adjustment; Remote Control Lever Load; Trim Tab Adjustment - TOHATSU M 40D2 Owner's Manual

ADJUSTMENT

1. Remote control lever load

■ EPO, EPTO
(Throttle friction adjustment screw)
To adjust the load of the remote
control lever, turn the throttle friction
adjustment screw on the front of the
remote control Box. Turn clockwise
to increase the load and counter-
clockwise to decrease it.
Lighter
Throttle friction
adjustment screw

2. Trim tab adjustment

If straight-line cruising can not be
achieved, adjust the trim tab located
under the anti-ventilation plate.
If the boat veers toward the right,
●
direct the trim tab towards A.
If the boat veers toward the left,
●
direct the trim tab towards B.
B
A
Heavier
Trim tab
Notes
● The trim tab also acts as an anode
to prevent electrolytic corrosion.
Therefore do not paint or grease
this part.
● After adjustment securely tighten
the trim tab fixing bolt.
● Check for looseness of the bolt and
the trim tab at regular intervals.
Due to corrosion, the trim tab will
wear down over time.
�������
!
● Inappropriate adjustment of trim
tab could cause steering difficulty.
After installing or readjusting trim
tab, check if steering load is even.
● Tighten trim tab bolt to specified
torque.
�������
!
● Be sure that outboard motor is
secured to transom or service
stand, or accidental drop or fall
of outboard motor could lead to
severe personal injury.
● Be sure to lock outboard motor
if it is tilted up, or accidental fall
of outboard motor could lead to
severe personal injury.
● Do not go under outboard motor
tilted up and locked, or accidental
fall of outboard motor could lead to
severe personal injury.
63
7