TOHATSU M 40D2 Owner's Manual page 24

24
INSTALLATION
2 Detach the bracket and set Cable
Harness B and Remote Control
Cables.
Having fixed the Remote Control
Cables to the bracket, tie them to
the bottom cowl.
3
Shift Cable
Clutch
Cable
Cord
Ass' y B
Battery Cord
!
Be careful not to loop the remote
control cables to a diameter of 406
mm (16 inches) or less.
3 Detach the throttle and shift cable
joints by removing the R-shaped
pins.
Throttle
Cable
Joint
R shaped
pin
Washer
Bracket
Screw
Throttle Cable
Grommet
Throttle
Cable
Meter
lead wire
�������
Washer
R shaped
Shift Cable Joint
● Thread at least 15mm (0.59 in.) of
the remote Control Cables through
the terminal eyes. Securely lock the
terminal eyes with lock nuts.
Remote control cable
4 Move the Remote Control lever
Forward, to Neutral and to Reverse
to confirm the shift is working, and
then set the lever no Neutral.
● Double-check that the Remote Control
Cables, the throttle cable and shift
cable have been connected correctly.
Move the Remote Control Lever
Forward until the first engaging point
(approx 32˚). The cable which is
moved first when the lever is turned
is a shift cable. Check that the shift
lever is in Neutral and the Free
pin
Lock nut
Cable joint
Approx. 10 mm (0.39 inch)
Fully opened
Free Accel
lever
Fully
closed