Table of Contents
Advertisement
5.5
TURNING THE PRODUCT OFF IN THE UNLIKELY EVENT OF A
REMOTE HANDSET OR ELECTRONIC FIRE CONTROL
MALFUNCTION.
5.5.1
In the unlikely event of the remote control handset malfunctioning (or if
lost or broken) after the appliance has been turned on, the fire can be
turned off via the emergency shut off switch on the control panel.
5.5.2
To turn the product off, firstly remove the ashpan from the fire.
5.5.3
Press and hold the emergency shut off switch until the fire shuts down.
The process may take up to sixty seconds to complete. (see Fig. 3
below).
5.5.4
When the fire has shut down, release the emergency shut off switch.
5.5.5
The appliance will now remain in the "off" position until activated by the
remote handset.
PLEASE NOTE : THERE IS NO MANUAL OVER-RIDE FACILITY FOR THE
REMOTE CONTROL SYSTEM AND THE EMERGENCY SHUT OFF SWITCH
SHOULD ONLY BE ACTIVATED IF YOU ARE SURE THE REMOTE
HANDSET OR EFC CONTROL IS MALFUNCTIONING, DAMAGED OR LOST.
Fig. 3
5.6
REPLACING THE BATTERIES (REMOTE & EFC MODELS ONLY)
ENSURE THE FIRE IS COOL BEFORE REPLACING BATTERIES
Remove the ashpan cover. The battery pack is located on the right hand side side
of the burner unit at the bottom. Carefully remove the pack and remove
batteries. Replace in the reverse order using 6 off 1.5V AA Alkaline Battery. It is
important that only an alkaline batteries are used, otherwise premature
battery failure and leakage may result. Fit the PP3 battery to the remote
handset by removing the rear cover and connecting the battery to the connecting
plug. Replace the cover on the handset.
33
Emergency Shut Off
Switch Position on
Control Panel.
- Quick Links:
- Operating Your Fire (Rc Variants)
Hide quick links:
Advertisement
Table of Contents
