3.5
FIXING THE INFRARED SENSOR IN POSITION - REMOTE
CONTROL MODELS ONLY
3.5.1
Due to the different fascia's that can be supplied with these fires, the
infrared sensor is supplied from the factory attached to a self adhesive
pad. This pad can therefore be attached to the hearth in a position to
suit the form of the fret assembly that is chosen with the product.
Fig. 17 below shows the self adhesive pad and infrared eye attached
to the flying lead, as supplied from the factory.
Fig. 17
Infrared Eye Sensor
3.5.2
Remove the backing paper from the self adhesive pad and position the
infrared eye in the air channels in the ashpan cover, so that the infrared
eye is flush with the front edge of the ashpan cover, as shown below in
Fig. 18. Check the operation of the fire / handset, as detailed in Section
3.7 and adjust the position of the infrared eye if necessary.
Fig. 18
Self Adhesive Pad
20
Infrared Eye
Flying Lead
Correct final position
of the Infrared Eye
Sensor