Operating Your Fire (Rc Variants) - Flavel FBFC**MN2 Installation, Maintenance & User Instructions

5.3 OPERATING THE FIRE (REMOTE CONTROL MODELS)
5.3.1 The Remote control handset generates an infrared signal, which will be
received by the sensor situated at the front right of your fire, behind the
ashpan cover. This infrared signal requires direct line of sight from the
handset to the sensor on the fire to ensure good operation. If the hands
set is lost or broken, the fire can be lit manually, see the user
instructions for details on how to operate the fire manually.
5.3.2 To light the appliance using the handset, point the handset at the fire
and press the 2 left hand buttons together. The fire will emit a "beep"
sound, the buttons can now be released. After a few seconds an
audible clicking can be heard and then the fire will light the pilot and
then light the main burner. The ignition cycle will take approximately 20
seconds.
5.3.3 To reduce the level of heat input on the fire, point the handset at the fire
and press the small flame button once (An audible beep will be heard)
and the heat input level will reduce to the low setting . Press
and continually hold the small flame button and the fire will reduce
incrementally to the low setting.
5.3.4 To increase the level of heat input on the fire, point the handset at the
fire and press the large flame button. (An audible beep will be
heard) and the heat input level will increase to the high setting
Press and continually hold the small flame button and the fire will
increase incrementally to the high setting.
5.3.6 To switch the appliance off completely, press the large round button on
the handset, the fire will then switch off. See Fig. 1 below for image of
handset.
Fig. 1
Off Button
Standby Button
WHEN TURNING THE FIRE "OFF" PLEASE ENSURE THAT THE PILOT
FLAME IS EXTINGUISHED. DO NOT LEAVE THE PILOT FLAME ONLY LIT.
High (Large Flame)
Low (Small Flame)
WARNING
If the fire goes out for any rea-
son or is turned off and it is
necessary to re-light the fire it
is important to allow the fire to
cool for 5 minutes before
attempting to re-light it.
31