Table of Contents
Advertisement
3.8
LIGHTING THE APPLIANCE - ELECTRONIC FIRE CONTROL
MODELS ONLY
3.8.1
To light the fire using the electronic fire control, press the ignition button
as indicated below in Fig. 21. The fire will emit a "beep" sound, the
buttons can now be released. After a few seconds an audible clicking
can be heard and then the fire will light the pilot and then light the main
burner. The ignition cycle will take approximately 20 seconds.
3.8.2
To reduce the level of heat input on the fire, press the small flame
button on the trim switch. (An audible beep will be heard)
3.8.3
To increase the level of heat input on the fire, press the large flame
button on the trim switch. (An audible beep will be heard)
3.8.4
To leave the fire in the standby mode (pilot only running) press the small
round button on the trim switch. (An audible beep will be heard)
3.8.5
To switch the appliance off completely, press the Ignition / Off button on
the trim switch, the fire will then switch off. (An audible beep will be
heard)
Fig. 21
WHEN TURNING THE FIRE "OFF" PLEASE ENSURE THAT THE PILOT
FLAME IS EXTINGUISHED. DO NOT LEAVE THE PILOT FLAME ONLY LIT.
Ignition / Off Button
Large Flame Button
Small Flame Button
23
Standby Button
- Quick Links:
- Operating Your Fire (Rc Variants)
Hide quick links:
Advertisement
Table of Contents
