2.4
GAS TIGHTNESS AND INLET PRESSURE (REMOTE CONTROL
MODELS).
2.4.1
Remove the pressure test point screw from the inlet elbow and fit a
manometer.
2.4.2
Turn on the main gas supply and carry out a gas tightness test.
2.4.3
Depress both the round buttons on the handset. The fire will then
commence its ignition sequence and will light to high. See page 25-38
for full details of the operating method for the fire.
Check that the gas pressure is 20.0 mbar (+/- 1.0mbar) 8.0 in w.g.(+/-
2.4.4
0.4 in w.g.)
2.4.5
Turn off the fire, remove the manometer and refit the pressure test point
screw. Check the pressure test point screw for gas tightness with the
appliance turned on using a suitable leak detection fluid or detector.
18