Table of Contents
Advertisement
3.7
LIGHTING THE APPLIANCE - REMOTE CONTROL MODELS ONLY
3.7.1
The Remote control handset generates an infrared signal, which will be
received by the sensor situated at the front right of your fire, behind the
ashpan cover. This infrared signal requires direct line of sight from the
handset to the sensor on the fire to ensure good operation.
3.7.2
To light the appliance using the handset, point the handset at the fire
and press the 2 left hand buttons together as shown below in Fig. 20
The fire will emit a "beep" sound, the buttons can now be released. After
a few seconds an audible clicking can be heard and then the fire will
light the pilot and then light the main burner. The ignition cycle will take
approximately 20 seconds.
3.7.3
To reduce the level of heat input on the fire, point the handset at the fire
and press the small flame button. (An audible beep will be heard)
3.7.4
To increase the level of heat input on the fire, point the handset at the
fire and press the large flame button. (An audible beep will be heard)
3.7.5
To leave the fire in the standby mode (pilot only running) press the small
round button on the handset.
3.7.6
To switch the appliance off completely, press the large round button on
the handset, the fire will then switch off.
Fig. 20
Off Button
Standby Button
WHEN TURNING THE FIRE "OFF" PLEASE ENSURE THAT THE PILOT
FLAME IS EXTINGUISHED. DO NOT LEAVE THE PILOT FLAME ONLY LIT.
22
High (Large Flame)
Low (Small Flame)
- Quick Links:
- Operating Your Fire (Rc Variants)
Hide quick links:
Advertisement
Table of Contents
