Sanremo Verde Instruction Booklet page 50

VERDE
11.1 - DISPLAY
The display is a touch-screen; during normal operation
of the machine the following screen is shown, while
during programming the screens shown on the display
are described in the relevant paragraph.
3
92
4
Max
1
Min
The following information is displayed on the screen:
1) Water level in the boiler
2) Boiler temperature
3) Unit temperature
4) Operation description/alarms
5) Day of the week
6) Time
12 - PROGRAMMING
The machine can be programmed on the display with
the Touch function.
12.1 - PROGRAMMING DOSES
The quantity of dispensing coffee can be programmed
for all buttons, except button (1)
continuous dispensing.
EN
WARNING: when the left button pan-
el is programmed, the programmed
doses are automatically transferred
to the other button panels.
• The coffee doses can be customised for each dis-
pensing unit by repeating the operations performed
in the first unit on the left for each unit.
Programming coffee doses
Start the machine as described in the relevant para-
graph.
Program the doses as follows:
• Fit the filter holder with coffee on the left unit of the
machine, as shown in the "OPERATION" paragraph.
• Position a cup or two cups under the unit according
to the type of programming to be performed.
• Press button (1).
3
94
°c °c
SANREMO
125
°c
10 : 57
6
Wed
5
which is used for
for at least 5 seconds until
Instructions for use and maintenance
the relevant LED (2) turns on flashing; the following
message is shown on the display:
PROGRAMMING DOSES SELECT IN 30 sec
2
3
• Within 30 seconds, press the dispensing button
to be programmed, e.g. button (3)
espresso coffee).
While dispensing, the button LED (3)
on, the other button LEDs turn off and the LED of
button (1)
• When the coffee reaches the desired quantity in
the cup, press button (3)
the quantity of dispensed coffee for that button will
be stored, the button LED (3)
the other LEDs of the buttons that still need to be
stored turn on.
• If necessary, repeat the aforementioned opera-
tions to program the other buttons as well; after
30 seconds without using any button, the dose
programming stage will be quitted.
Programming tea doses
• Enter the programming function as described for
the coffee, then when LED (2) of button (1)
turns on flashing, press button (4)
dispensing hot water; when the desired quantity is
reached press button (4) again to stop dispensing.
• After 30 seconds without using any button, the dose
programming stage will be quitted.
16 / 29-EN
2
1 4
flashes.
to stop dispensing;
turns off while
02-2014
(single
remains
to start