Sanremo Verde Instruction Booklet page 46

VERDE
8. COMMISSIONING
8.1 - FIRST START-UP
WARNING: first start-up operations
must be performed by a specialised
and authorised technician.
• Open the water supply tap upstream of the machine.
• Open the steam supply, turning the knob anti-clock-
wise (1).
• Power on the machine power supply bringing the
breaker upstream of the machine to ON.
• Turn the main switch (2) to "1" giving voltage to
the operating electrical circuits, LED (3) turns on
to indicate that the circuit is live, the displays light
up and the automatic filling program shown on the
display is started (4).
If automatic filling does not take
place within 90 seconds, the ma-
chine stops and the LEDs above
the unit button panels light up and
flash.
Turn the machine on and off to com-
plete the water intake in the boiler.
• Wait until air mixed with water comes out of the
steam dispenser, then close the steam tap that was
previously opened.
• Dispense water from the units, without fitting the
filter holders, press one of the buttons (5), (6), (7),
(8), located on the front button panels, checking that
water comes out properly, venting any air bubble
EN
present in the circuit.
Press the same button again to stop dispensing.
• Dispense hot water by pressing button (9), dispens-
ing will stop automatically when the quantity set in
the program is reached.
• Wait until the unit set temperature (94 °C) is
reached, as shown on the displays (4) located above
each unit, as well as the temperature of the boiler
shown on display (4). Check on pressure gauge
(10) that the boiler pressure is approx. 1 - 1.2 bar
(0.1 - 0.12 MPa) and that the water supply pressure
from the mains is not above 4 Bar (0.4 MPa).
• Position a jug with handle under dispenser (11) and
dispense water by pressing button (9), checking
that dispensing is correct; dispensing will stop au-
tomatically when the quantity set in the program is
reached.
Instructions for use and maintenance
5 6
1
3
10
12 / 29-EN
9
7 8
4
2
02-2014