Cleaning The Fire; Cfm Europe Ltd - Flavel Windsor Installation, Maintenance And User Instruction

5.6 Cleaning - WARNING
Before attempting any cleaning operation ensure that the fire has been allowed to
fully cool. The Brass fret that was supplied with the fire (dependent upon model
chosen) is real brass and therefore will discolour with use and should be cleaned
with a proprietory metal polish. The chrome & brass effect trims and chrome effect
fret that was supplied with the fire (dependent upon model chosen) should only be
cleaned with a clean, damp cloth.
The trim is best cleaned in position on the fire when the appliance is not running
and is cool. Black painted metal parts should be gently cleaned with a damp cloth.
Cleaning the Fuelbed
We do not recommend cleaning of the coals or fuelbed components as these are
fragile and damage may result. None of these parts must be washed or
exposed to any cleaning agents or water. Any damaged parts must be
replaced by contacting your dealer or telephoning CFM Europe Ltd. on the number
stated on the rear cover of this book. The coals or pebbles must only be replaced
with a complete and genuine replacement set and the fire must never be run with
the wrong number or damaged coals / pebbles. The fuel-bed must be carefully re-
assembled as stated in section 5.4 & 5.5 (dependent upon model chosen), pages
28-31
Removal / Re-Fitting the Trim
Models supplied with three piece trim
a) Fit the 2 side pieces of the trim by overlapping the lips of the trim
over the side lips of the firebox, and securing with the magnets
provided
b) Fit the top piece of the trim by overlapping the lips of the trim over
the lips of the firebox and over the 2 side trims.
Models supplied with one piece trim
a) Fit the outer trim assembly to the firebox with the magnets
provided.
PEBBLE & DRIFTWOOD MODELS
a) Fit the outer trim assembly to the firebox with the magnets
provided. NB. The fret is a loose item and located beneath the trim
assembly.
Supplied By www.heating spares.co Tel. 0161 620 6677
44