Installation Of Fire; Unpacking The Fire; Installing The Fire Box - Flavel Windsor Installation, Maintenance And User Instruction

INSTALLATION OF FIRE

2.1

UNPACKING THE FIRE

Carefully lift the fire out of the carton. Remove the loose item packaging carefully
from the front of the appliance. Check the contents as listed :-
Packing Check List - Coal Fuelbed Models
1off Fire box / burner assembly
1off Boxed ceramic base and 7 synthetic coals
1off Loose items bag.
1off Trim (3 piece or 1 piece dependent upon model chosen)
1off Boxed Fret & Ashpan cover (dependent upon model chosen)
1off each Installation / User book (Combined)
Packing Check List - Pebble & Driftwood Fuelbed Models
1off Fire box / burner assembly
1off Boxed ceramic base and 7 synthetic pebbles (4 large, 3 small) or
driftwood pieces
1off Loose items bag.
1off Chrome Effect Trim / Ashpan
1off each Installation / User book (Combined)
2.2

INSTALLING THE FIRE BOX

Establish which type of flue you are intending to install the fire in to :-
225 x 225mm (9 inch x 9 inch) brick built chimneys
175mm (7 inch) diameter lined brick or stone flue, or insulated pre-fabricated
metal flue box to B.S. 715.
When installing into 125mm (5 inch) diameter lined brick or stone flue, or
insulated pre-fabricated metal flue box to B.S. 715 and pre-cast flues the
restrictor baffle must not be fitted.
A spillage test must always be carried out to check satisfactory
clearance of flue products, regardless of the type of flue the
appliance is being fitted to.
Supplied By www.heating spares.co Tel. 0161 620 6677
SECTION 2
10