Assembling The Driftwood Fuelbed - Flavel Windsor Installation, Maintenance And User Instruction

5.5 ASSEMBLING THE FUEL-BED - Driftwood Fuelbed Model
a) Place the fuelbed base centrally on to the fuelbed support and push
fully backwards to the rear face of the fibre boards Make sure that the
fuelbed base is located centrally in the fire box. See Fig. 32 below
Fig. 32
b) Position the piece of driftwood with the letter "A" stamped onto the
bottom face of it in the position at the left-hand side of the fuelbed
matrix. Ensure the positioning grooves as shown are on the top face of
the piece of driftwood. See Fig. 33 below.
Fig. 33
Driftwood Piece "A"
Grooves in top face
as detailed in
section b)
Supplied By www.heating spares.co Tel. 0161 620 6677
38