Cleaning The Fire - Flavel Finesse FSRC**MN Installation, Maintenance & User Instructions

5.3 Cleaning - WARNING
Before attempting any cleaning operation ensure that the fire has been allowed to
fully cool. The fascia is best cleaned in position on the fire when the appliance is
not running and is cool. Black painted metal parts should be gently cleaned with a
damp cloth.
Cleaning the Fuelbed
We do not recommend cleaning of the coals or fuelbed components as these are
fragile and damage may result. None of these parts must be washed or
exposed to any cleaning agents or water. Any damaged parts must be
replaced by contacting your dealer or telephoning BFM Europe Ltd. on the number
stated on the rear cover of this book. The coals or pebbles must only be replaced
with a complete and genuine replacement set and the fire must never be run with
the wrong number or damaged coals / pebbles. The fuel-bed must be carefully
re-assembled as stated in section 5.4 & 5.5 (dependent upon model chosen),
pages 31-34
Removal / Re-Fitting the Fascia
a) Fit the Fascia assembly to the firebox by hooking over the bracket and
securing with magnets provided at the base.
USER REPLACEABLE PARTS
The only user replaceable parts on this fire are the fuelbed components and
coals or pebbles which may be replaced as described in the above section.
Replacement of any other parts must be carried out by a competent person such
as a CORGI registered gas installer. The part numbers of the user replaceable
parts are as follows, these are available from BFM Europe Ltd. who may be
contacted at the number on the rear cover of this book.
Coal Pack
Pebble Pack
B-67050 Coal Fuelbed Matrix
B-68240 Pebble Fuelbed Matrix
31
B-67040
B-68230