Printing Area - Minolta Magicolor 3100 Series Service Manual

This function specifies the IOT performance when the controller did not have the × 2
feeders satisfy the following performance.
*1:Process control means TC control, potential control, cleaning cycle, REGI control
*2:The print may not start for a certain time after receiving the start command due to
Refer to Chart 6 Operational Principal, for details of Process control.
Reference: Unit "PPM" stands for "prints per minute" indicating number of prints per minute.
Paper mode
Plain paper/Woodfree paper
mode (A4/LET SEF)
Thick aper/Label mode
(A4/LET SEF)
OHP mode
Envelop/Postcard mode

4.13 Printing Area

4.13.1 Usable paper size
Minimum and maximum paper size usable for this printer are as follows:
Minimum usable paper size:Width 88.9mm (3.5inch) × length 139.7mm (5.5 inch)
(when using MSI)
Maximum usable paper size:Width 215.9mm (8.5 inch) × length 355.6mm (14 inch)
(when using MSI).
4.13.2 Maximum printable area
Maximum area where image can be printed is as follows:
Width: 210.9mm (8.3 inch) × length: 351.6mm (13.8 inch)
4.13.3 Guaranteed printing area
Area for which the image quality is guaranteed as follows:
Area except for 4mm (0.1575 inch) from edges of the paper.
Maximum area for which the image quantity is guaranteed as follows:
Width: 207.9mm (8.2 inch) × length: 347.6mm (13.7 inch)
8-410
and that the engine stops paper feeding for a certain time during the continuous
printing operation.
prior job running conditions.
Standard mode
(600dpi)
Simplex
(ppm)
16
8
8
8
Continuous printing speed
Fine mode
(1200dpi)
Duplex Simplex
(ipm) (ppm)
10 8
– 8
– 8
– 8
High gross mode
(600dpi)
Duplex Simplex
(ipm) (ppm)
5 8
– –
– –
– –
Duplex
(ipm)
5
–
–
–