Table of Contents
Advertisement
Figure 2-1b
USE TEMPLATE ON PAGE 21
NOTE: The mower's exhaust radiates heat from the
muffler which can be potentially drawn through the air
intake. Provided is a heat guard to reduce the heat
drawn into the air intake.
Remove the (2) bolts shown (Figure 2-1c) from the rear
of the mower. Place the heat guard P#(C0011) over top
of the muffler with the flap pointing downward so that the
heat will travel to the rear of the mower. Align the holes
in the heat guard to the holes of the bolts that were
removed previously from the mower. Using the
previously removed bolts, fasten the guard to the rear of
the mower. See Figure 2-1c for more details on how to
position heat guard.
Figure 2-1c
Note: If equipped with a Donaldson air cleaner, rotate
unit for clearance of the top main frame assembly.
To rotate Donaldson air cleaner, loosen spring tension
bolt on air cleaner bracket, rotate air cleaner as needed
for clearance as shown in Figure 2-1d, and tighten.
Drill (2) 13/32" Holes
PER SIDE
Heat Guard
Bolts For Mounting Guard
Figure 2-1d
NOTE: If air cleaner still touches after installing box
assembly P#(A0794), there is adjustabity designed into
the frame legs. Raise the main frame assembly
P#(A0680) up one set of holes as needed for clearance.
Always keep the lowest height to ground clearance
possible for the collection system, which will improve
overall stability.
NOTE: PREDATOR PRO MODELS SEE PAGE 13
2-2 PTO Assembly Installation
Position the PTO assembly over the holes that were
drilled in the right rear mower chassis. Fasten the
assembly using (2) 3/8"-16 x 1" HHCS P#(K1191) and
(2) 3/8"-16 flange nuts P#(K1215). See Figure 2-2 for
reference.
Figure 2-2
6
Loosen Bolt To Rotate Air Cleaner
Air Cleaner In Rotated Position
Use (2) 3/8"-16 x 1" HHCS
and (2) 3/8"-16 Flange Nuts
Advertisement
Table of Contents
