Table of Contents
Advertisement
Figure 2-2d
2-3 Top Main Frame Assembly
Installation
Place the top main frame assembly P#(A0944) (Figure
2-3) onto the main frame legs and fasten each side by
using (1) 3/4"-10 x 1-1/2" HHCS P#(K0364), (1) 3/4"-10
nyloc nut P#(K1433), (1) ½"-13 x 1" HHCS P#(K1231),
and (1) pivot frame handle P#(A1001). The handles are
used to pivot the frame to the rear for mower engine
access. Be sure that the handles are tight and the frame
is in the upright position before each use!
Figure 2-3
Top Main Frame Assembly
3/4"-10 x
1-1/2" HHCS
RED/VIOLET
BRN/YELLOW
1/2"-13 x1"
HHCS
Pivot Frame Handle
PECO
BAGGER
SWITCH
2-4 Lift Handle Installation
The various parts of the box handle assembly
P#(A0614) must be attached to the container frame.
Page 9 shows the orientation and location of the
components. Slide the lift handle into the slot in the
handle mount bracket P#(B1730) on the grass container.
It may be necessary to remove the handle grip
P#(J0522) to allow the handle to fit through the slot.
Before attaching the handle, hook one end of the spring
P#(J0176) into the hole on the underside of the handle.
Hook the other end of the spring into the open hole in
the handle mount bracket. Fasten the handle to the
grass container frame by using (1) 3/8"-16 x 2" HHCS
P#(K1208) and (2) 3/8"-16 flange nuts P#(K1215). At this
point the handle can pivot back and forth in the slot of
the handle mount bracket. With the handle in place,
fasten the ball joint P#(K1442) to the end of the latch rod
P#(A0260) (Page 9). Tighten to approximately half way
down the threads of the latch rod. Slide the ball joint into
the hole on the latch hook P#(B1529). Use (1) 5/16"-24
hex nut P#(K1444) and (1) 5/16" lock washer P#(K0043)
to fasten the ball joint to the latch hook. Attach the
opposite end of the latch rod into the handle. Fasten the
rod to the handle by using (1) 3/32" x 3/4" cotter pin
P#(K0094). Adjust the rod to allow the hook to close the
box door completely.
Refer to pages 9,10,11,12 and 13 for exploded parts
drawings and photographs of the complete assembly.
7
Advertisement
Table of Contents
