Table of Contents
Advertisement
2-3 Main Frame Leg Installation
Install the left lower frame leg assembly P#(A0681) to
the rear left side of the chassis by using (2) 3/8"-16 x 1"
HHCS P#(K1191), (2) 3/8"-16 flange nuts P#(K1215),
and (1) nut and bolt previously removed from the mower.
Refer to the figures below.
Figure 2-3a
Figure 2-3b
2-4 Top Main Frame Assembly
Installation
Place the top main frame assembly P#(A0680) (Figure
2-3) onto the main frame legs in the lowest hole possible
for clearance, and fasten by using (4) 3/8"-16 x 1" HHCS
P#(K1191) and (4) 3/8"-16 flange nuts P#(K1215), (2)
bolts and nuts per side.
NOTE: This mower comes with different engine options.
Diesel and water-cooled engines may cause the main
frame assembly to be mounted in a higher hole location
for clearance. The main frame legs are designed with
multiple mounting holes for adjustability. Always mount
the main frame assembly in the lowest set of holes
possible for clearance. Doing this will provide the lowest
height-to-ground clearance for the collection system,
which will improve overall stability. See Figure 2-4.
(2) 3/8"-16 x 1" HHCS
(2) 3/8"-16 Flange Nuts
Replace Existing Hardware
Figure 2-4
(2) 3/8"-16 x 1" HHCS
(2) 3/8"-16 Flange Nuts
Per Side
2-5 Lift Handle Installation
The various parts of the handle assembly P#(A0273)
must be attached to the container frame. Page 9 shows
the orientation and location of the components. Slide the
lift handle into the slot in the handle mount bracket
P#(B1730) on the grass container. It may be necessary
to remove the handle grip P#(J0522) to allow the handle
to fit through the slot.
Before attaching the handle, hook one end of the spring
P#(J0176) into the hole on the underside of the handle.
Hook the other end of the spring into the open hole in
the handle mount bracket. Fasten the handle to the
grass container frame by using (1) 3/8"-16 x 2" HHCS
P#(K1208) and (2) 3/8"-16 flange nuts P#(K1215). At this
point the handle can pivot back and forth in the slot of
the handle mount bracket. With the handle in place,
fasten the ball joint P#(K1442) to the end of the latch rod
P#(A0260) (Page 8). Tighten to approximately half way
down the threads of the latch rod. Slide the ball joint into
the hole on the latch hook P#(B1529). Use (1) 5/16"-24
hex nut P#(K1444) and (1) 5/16" lock washer P#(K0043)
to fasten the ball joint to the latch hook. Attach the
opposite end of the latch rod into the handle. Fasten the
rod to the handle by using (1) 3/32" x 3/4" cotter pin
P#(K0094). Adjust the rod to allow the hook to close the
box door completely.
Refer to pages 9-12 for exploded parts drawings and
photographs of the complete assembly.
7
Main Frame Assy.
Lower Frame Leg
Advertisement
Table of Contents
