Trim Set (Shift+Trim) - Akai DD1500 User Manual

TRIM SET (SHIFT+TRIM)

It is possible to set the certain parameters relating to trimming cue in the TRIM SET page.
Pressing SHIFT+TRIM will display this screen:
The fields on this page are:
SLIP TYPE
DATA +/- KEYS
NUMERIC +/- KEYS
OVERLAP LIMIT
Pressing EXIT will leave this screen at any time.
Version 2.00 - March, 1996
This allows you set whether what you do in TRIM affects all
audio on the track or only the cue you are trimming. The
choices here, not surprisingly, are ONLY CUE and SLIP
WHOLE TRACK.
Here you may set the amount the DATA +/- keys will
'nudge' a trim point. The usual selection (and hence the
default) is 1 frame. You may select from 1-25 frames (or 24
or 30 depending on the frame rate of the timecode type
you are using).
This field allows you to set the amount by which the
numeric keypad's +/- keys will 'nudge' a trim point. The
default is 1 sub-frame and you may select from 1-9 sub-
frames.
This allows you to se the maximum amount cues can be
overlapped when using trim to extend one cue over
another. The range is 0 (no overlap) to 80mS.
EDITING - 14
Page 139