Changing To Mig Welding; Setting Preflow Sequence Display - Miller Electric Welder Owner's Manual

11-2. Changing To Mig Welding

Mode
Select
> Process
Sequence
SharpArc
Card
> Process
Sequence
SharpArc
Card

11-3. Setting Preflow Sequence Display

>Process
Sequence
SharpArc
Card
Mode
Select
Process
> Sequence
SharpArc
Card
Parameter
Select
OM-196 188 Page 96
1
> Prg 1
AdaptPulse
035" Steel
Argon – Oxy
Parameter
Select
Prg 1
> AdaptPulse
035" Steel
Argon – Oxy
> Prg 1
MIG
>Preflow
0.0 Sec
3
2
Preflow
> 0.0 Sec
Set Desired Time
Parameter
Select
Increase/Decrease
> Process
Sequence
SharpArc
Card
Increase/
Decrease
1
> Preflow
1.2 Sec
Increase
Proceed to next Section
1 Setup Pendant Display
Default display when unit is first
turned On, at other times use mode
select button to select Process.
Go to Section 11-3.
Prg 1
> MIG
1 Setup Pendant Display
When unit is turned On, Process is
the default mode. Use mode select
button to select Sequence.
2 Parameter Select Button
Use parameter select button to
select parameters.
3 Preflow Parameters Display
Preflow can be adjusted from 0-9.9
seconds. If value set is zero (0),
there is no Preflow sequence.
Go to Section 11-4.