Section 15 - Control Menu; Using Menu Display - Miller Electric Welder Owner's Manual

The control menu allows the user access to rise time setting that controls rise and fall time of the pulse square wave.
Changing the rise time setting changes the square wave shape by rounding off the corners, and makes it possible to
quiet the pulse arc by just changing the rise time.

15-1. Using Menu Display

1
C o n t r o l
Front Panel Display
SECTION 15 – CONTROL MENU
2
Increase
Button
Decrease
Button
3
> Rise Time
Adaptive > 800
AutoConfig
Retract
Pulse Panel Display
1 Front Panel Control Display
Front panel display during control
setting.
2 Setup Pendant Increase And
Decrease Buttons
3 Power Switch On Front Panel
Press and hold down both buttons
while turning On unit. Release
buttons when Control appears on
the front panel display.
4 Setup Pendant Control
Display
Follow this procedure any time
access is required. To save any
changes made while in the control
display, and/or to exit the control
display, cycle power off and back
on at power switch.
4
A/ms
OM-196 188 Page 119