Selecting Or Changing Access Code - Miller Electric Welder Owner's Manual

14-3. Selecting Or Changing Access Code

NOTE
Access
Setup
Display
>Access
Mig Type
Aux Out
Voltage
Press Mode
Select
Enter
Access
Code
Access code works only when a data card is inserted (see Section 13).
Code
> Off
Code
> On
AAA
Code
On
> AAA
Press
Code
On
> ZWX
Press
Turn Power Off And Back On
And Access Security Display
> Code AAA
Press
1
Increase
Parameter
Select
Increase/Decrease
To Set Code
Parameter Select
To Move Indicator
2
1 Code Display
With code off, access to the setup
displays is not restricted.
With code on, the operator must
know and enter the access code to
access or change any of the setup
displays.
2 Access Display
With a code set, this display
appears when power is turned on
while holding the pulse panel Mode
and Parameter Select buttons.
Press Parameter Select button to
enter access code. When the
correct letter is entered, the
indicator automatically moves to
the next character. When the final
access code letter is entered, the
display automatically changes to
the initial setup display.
OM-196 188 Page 109