Section 9 - Getting Started For Pulse Welding; Weld Cycle For Pulse Welding; Setting Preflow Sequence Display - Miller Electric Welder Owner's Manual

SECTION 9 – GETTING STARTED FOR PULSE WELDING

9-1. Weld Cycle For Pulse Welding

Wire
Speed
Speed
Preflow
Time
Weld Run-In
Start Setting

9-2. Setting Preflow Sequence Display

Process
> Sequence
SharpArc
Card
1
Mode Select
3
> Prflw
0.0 Sec
Parameter
Select
OM-196 188 Page 88
Start Robot
Power Motion
Start
Weld
Speed
Run-In
WFS
Arc
Strike
> Prflw
0.0 Sec
Parameter
Select
Prflw
> 0.0 Sec
Set Desired Time
Increase/
Decrease
.
The type of robot connected determines what
combination of parameters are available.
Weld Time
Crater Time
Crater
Speed
Weld Arc
Stop Out
2
> Prflw
1.2 Sec
Parameter
Select
Increase
Proceed to next Section.
Retract Time
Postflow
Time
1 Mode Select Button
When unit is turned On, Process is
the default mode, at other times,
use mode select button to select
Sequence.
2 Parameter Select Button
Use parameter select button to
select parameters.
3 Preflow Parameters Display
Preflow can be adjusted from 0-9.9
seconds. If value set is zero (0),
there is no Preflow sequence.
Go to Section 9-3.
Time
Ref. S-0271