Selecting Security Lock - Miller Electric Welder Owner's Manual

13-7. Selecting Security Lock

NOTE
Access
Setup
Display
1
> Security
Press Mode
Select
Prog 2
> Lock On
Parameter
Select
> Prog 2
Lock On
OM-196 188 Page 106
Security lock works only when a data card is inserted.
Sequence > Prog 1
SharpArc Lock Off
Card
Prog 2
> Lock Off
Increase
> Prog 3
Lock Off
Increase
2
Increase
> Prog 2
Lock Off
Parameter
3
Select
1 Security Display
Use this display to lock a program's
weld parameters so that changes
can not be made using pulse panel
controls.
2 Program Number
Choose the program number (1
through 8) to be locked.
3 Program Lock Display
When lock is off a program, the
operator can change all weld
parameters of that program without
restriction.
With lock on a program, the
operator cannot change
parameters of that program.