Section 12 - Setting Sharparce Control; Selecting And Adjusting Sharparce Control - Miller Electric Welder Owner's Manual

SECTION 12 – SETTING SharpArcE CONTROL

12-1. Selecting And Adjusting SharpArcE Control

> Process
Sequence
SharpArc
Card
1
> SharpArc
OM-196 188 Page 100
> Prg 1
Pulse
035" Steel
Argon – Oxy
Mode
Select
>SharpArc
Process
0
Sequence
Card
Parameter
Select
SharpArc
> 0
Set Desired Value
Increase/Decrease
1 SharpArc
SharpArc is used to adjust arc
cone width and arc characteristics.
Use mode select button to move >
to select SharpArc. Use Display
Control to adjust Arc setting.
SharpArc setting range is from 0
to 20. The factory default is set at
zero (0). When Arc value is
increased toward 20, the arc cone
narrows and the weld puddle
becomes less fluid.
SharpArc SharpArc
> 10 > 10
Parameter
Select
> SharpArc
10