Using Setup Displays - Miller Electric Welder Owner's Manual

14-2. Using Setup Displays

1
S e t u p
Front Panel Display
OM-196 188 Page 108
2
Mode Parameter
Select Select
3
Access > Volt Min
Mig Type 10.0 Volt
Aux Out
Voltage
Setup Pendant Display
1 Front Panel Setup Display
Front panel display during setup.
2 Pulse Panel Mode And
Parameter Select Buttons
3 Power Switch On Rear Panel
Press and hold down both buttons
while turning On unit.
4 Setup Pendant Display
Follow this procedure any time
access is required. Once in the set-
up displays, use the Mode Select
button to select a particular display.
To save any or all of the changes
made while in the setup displays,
and/or to exit the setup displays,
turn power to the unit Off and back
On.
4