Setting Retract On/Off; Setting Sharp Start On/Off - Miller Electric Welder Owner's Manual

15-5. Setting Retract On/Off

Access
Control
Display
Press Mode
Select
>Process
Sequence
SharpArc
Card

15-6. Setting Sharp Start On/Off

Access
Control
Display
Press Mode
Select
>Process
Sequence
SharpArc
Card
OM-196 188 Page 122
Adaptive
AutoConfig
> Retract
ShrpStrt
Power
> Prg 1
Switch
Pulse
035" Steel
Argon – Oxy
AutoConfig
Retract
> ShrpStrt
Exit
Power
> Prg 1
Switch
Pulse
035" Steel
Argon – Oxy
1
> Retract
On
Increase/
Decrease
> Retract
Off
Mode
Or
Select
Go To
Section 15-6
1
> ShrpStrt
On
Increase/
Decrease
> ShrpStrt
Off
Mode
Or
Select
Go To
Section 15-4
1 Retract Display
Settings allow user to turn the re-
tract feature On or Off. The retract
feature allows the user to set a time
and wire feed speed to pull wire
away from work when the weld is
done.
Use Increase or Decrease button to
change setting. If the retract feature
is turned On, a weld sequence step
is added in the process screens.
Press Mode Select button to go to
next parameter or cycle power off
and back on at power switch to sav-
e setting and exit Control menu.
1 Sharp Start Display
Settings allow user to turn the sharp
start feature On or Off.
.
Sharp start should normally be
left On. The ability to turn sharp
start Off is provided in case the
user experiences problems
with weld ends using flux cored
wires.
Use Increase or Decrease button to
change setting.
Press Mode Select button to go to
next parameter or cycle power off
and back on at power switch to sav-
e setting and exit Control menu.