Clock - DSC PowerSeries Neo 3G8080 Installation Manual

Section
017
019
024
041
Swinger Shutdown
377
377
Communication Delay
Wireless Device Low
377 Battery Transmission
380
380
380
382
804 [sensor #]

Clock

The HSPA/CDMA module sets the panel clock when it connects to Alarm.com and then updates it every 18
hours. It is important to select the correct panel time zone on the Alarm.com website, or the panel time will
not be accurate. If a system is powered up before the customer account has been created, the time zone will
default to Eastern Standard Time.
Option
6
6
5
-
(Maintenance)
AC Failure Random value between
Delay
1
2
5
6
003 Five minute delay [07]
Value
OFF
Set according to
dealer's Alarm.com
setting
OFF
00
014
001 and 030
001
ON
OFF
OFF
OFF
- 15 -
Description
Daylights saving time must be disabled to
ensure panel time is accurate
Enables Duress Code changes from
Alarm.com
Realtime clock must be disabled to ensure
panel time is accurate
User Access Codes must be 4-digits
Swinger Shutdown for maintenance signals
must be set to 014 to ensure trouble
notifications can be sent.
AC Failure Communication Delay should be
set between 001 and 030 to ensure
notifications for power failures are received
Wireless Device Low Battery Transmission
Delay should be set to 001 to ensure
notifications for low batteries are received
Communications must be enabled for the
module to communicate with the panel
System should transmit alarm restores
immediately when the zone is restored
The redundant communications method must
be set as backup.
AC Failure Transmission Delay should be in
minutes
High Traffic Shutdown should be set to five
minutes for devices being used with
Alarm.com's Activity Monitoring.
Note: This feature may reduce the battery
life of wireless PIR sensors. In order to
avoid this, hardwired PIR sensors may be
used instead.
Installation