4.3.1 Boot Config
On this page you can configure the boot file of the switch. When the switch is powered on, it will
start up with the startup image. If it fails, it will try to start up with the backup image. If this fails too,
you will enter into the bootutil menu of the switch.
Choose the menu System → System Tools → Boot Config to load the following page.
The following entries are displayed on this screen:
Boot Table
Select:
Unit:
Current Startup
Image:
Next Startup Image:
Backup Image:
Figure 4-12 Boot Config
Select the unit(s).
Displays the unit ID.
Displays the current startup image.
Select the next startup image.
Select the backup boot image.
27