Routing Table - TP-Link T1700G-28TQ User Manual

Detail Information

Interface ID:
IP Address Mode:
IP Address:
Secondary IP:
Interface Status:
Line Protocol
Status:
Admin Status:
Interface Name:
Interface Setting Detail Information

Displays the detailed setting information of the interface.

10.2 Routing Table

This page displays the routing information summary generated by different routing protocols.
Choose the menu Routing→Routing Table→Routing Table to load the following page.
Routing Information Summary

Protocol:
Destination/Mask:
Next Hop:
Distance:
Metric:
Displays the ID of the interface, including VLAN ID, loopback
interface, routed port and port-channel ID.
Displays the IP address allocation mode.
None: without ip.

Static: setup manually.

DHCP: allocated through DHCP.

BOOTP: allocated through BOOTP.

Displays the IP address and subnet mask of the interface.
Displays Secondary IP Address and subnet mask.
Displays the interface current working status, which is up when
Admin Status is enable, line protocol is up and IP address is set.
Displays the line protocol status, which is up if any up-link port is
connected to the interface.
Displays the Admin status. Choose Disable to disable the
interface's Layer 3 capabilities.
Displays the name of the interface.
Routing Table
Figure 10-2
Displays the protocol of the route.
Displays the destination and subnet of the route.
Displays the IP address to which the packet should be sent next.
Displays the management distance of the route. The smaller the
distance is, the higher the priority is.
Displays the metric of the route.
155