9.2.2 Port Config
On this page you can configure MLD snooping function with each single port.
Choose the menu Multicast→MLD Snooping→Port Config to load the following page.
The following entries are displayed on this screen:
Port Config
UNIT/LAGS
Select:
Port:
MLD Snooping:
Fast Leave:
LAG:
Figure 9-14 Port Config
Click unit number to configure the physical ports of this unit
member. Click LAGS to configure the link aggregation
groups.
Select the port you want to configure.
Displays the port number.
Select Enable/Disable MLD snooping for the desired port.
Select Enable/Disable Fast Leave feature for the desired
port. If Fast Leave is enabled for a port, the switch will
immediately remove this port from the multicast group upon
receiving MLD done messages.
Displays the LAG number.
138