Rear Panel - TP-Link T1700G-28TQ User Manual

Name
Link/Act
1000Mbps
Green
25-28
Yellow
 Unit ID LED: Designed to display the stack Unit ID of the switch. For the switch that does not
join any stack system, it displays its default Unit ID. To modify the default unit number, please
logon to the GUI of the switch and go to Stack→Stack Management→Stack Config page and
configure the New Unit ID. The new Unit ID will take effect after you reboot the switch.
 Reset: Press this button for 5 seconds or above to reset the software setting back to factory
default settings.
 10/100/1000Mbps RJ45 Ports: Designed to connect to the device with a bandwidth of 10Mbps,
100Mbps or 1000Mbps. Each has a corresponding 1000Mbps LED and Link/Act LED.
 SFP+ Ports: Port 25-28, designed to install the 1Gbps SFP transceiver, 10Gbps SFP+
transceiver or SFP+ cable.

2.2.2 Rear Panel

The rear panel of T1700G-28TQ features a power socket, a Kensington security slot and a
Grounding Terminal (marked with ).
 Kensington Security Slot: Secure the lock (not provided) into the security slot to prevent the
device from being stolen.
 Grounding Terminal: The switch already comes with Lightning Protection Mechanism. You
can also ground the switch through the PE (Protecting Earth) cable of AC cord or with Ground
Cable.
Status
A device is connected to the corresponding port but no
On
activity
Data is being transmitted or received
Flashing
No device is connected to the corresponding port
Off
A 1000Mbps device is connected to the corresponding
On
port
A 10/100Mbps device or no device is connected to the
Off
corresponding port
A 10Gbps device is connected to the corresponding port,
On
but no activity
Data is being transmitted or received
Flashing
A 1000Mbps device is connected to the corresponding
On
port, but no activity
Data is being transmitted or received
Flashing
No device is connected to the corresponding port
Off
Figure 2-2 Rear Panel
Indication
7