Steam Ironing; Spray; Shot Of Steam - Fakir VEZUV Instruction Manual

GB

Steam ironing

Spray

Shot of steam

18
OPERATING
1. Fill the iron as described in the section "how to fill the water
tank".
2. Plug the iron into the mains.
3. Steam ironing is only possible when the highest
temperatures shown on the temperature control are
selected .
Otherwise ,water may escape through the soleplate.
4. Wait until the pilot light goes out , which indicates that the
selected temperature has been reached.
5. Turn the steam button to the required position.
6. When the ironing is finished and during breaks in ironing ,
place the iron in its upright position.
7. Disconnect the iron from the mains supply . Pour of any
remaining water and leave the iron to cool off.
1. The spray can be used in any position, either in dry or
steam ironing, as long as the water tank is filled with water.
2. Press the spray button for this function
NOTE!
Bu özelliği ilk olarak kullanacağınız zaman düğmeye
birkaç kez This button has to be pressed repetitively
to start this function for the first time.gerekebilir.
Shot of steam give extra steam for removing persistent
wrinkles.
1. Place the temperature selector at the "max"(fig.3)position
and wait until the pilot light goes out
2. Wait for a few seconds for the steam to penetrate the fibre
before pressing again.
NOTE!
For the best steam quality, do not use more than
three successive bursts each time. Several pumping
actions are needed to start this function.
Excessive use of this feature will cause the iron to cool ,
ensure that the pilot light is out, before operating the shot
of steam control.