Operating; Steam Ironing; How To Fill The Boiler Tank Before Use; How To Start The Appliance - Fakir GLARE Instruction Manual

Steam Ironing

How to fill the boiler
tank before use
How to start the
appliance

OPERATING

NOTICE!
Before ironing, check that the garment to
Be ironed is suitable for steam ironing.
DO NOT UNSCREW THE BOILER CAP UNLESS YOU
ARE SURE THAT THE APPLIANCE HAS BEEN
UNPLUGGED FROM THE OUTLET (FIG. 2) AND THAT
THE PRESSURE INSIDE HAS BEEN RELEASED.
Do not unscrew the boiler cap unless you are sure that the
appliance has been unplugged from the outlet
When water in boiler is lack," Lack warter" pilot lamp(13)
lights up,
Unscrew safety cap (7). Pour 1.0litres (12) of normal
tap water into the tank (figure 2) by means of funnel. Screw
the safety cap on tightly (7).
Check that the voltage indicated on the data plate
corresponds with that of the local network before
connecting the appliance to the supply mains.
The appliance uses ordinary tap water.
Always remove the plug from the power socket before
filling the boiler
Connect the appliance to the power supply.
Press the boiler's switch (4) and wait for the water to start
boiling (about 8
minutes). Next, press switch (5) to turn on the iron and
then select the desired temperature by means of the
thermostat knob (9).
When the light (11) goes off, the set temperature has been
reached and the iron is ready for use. It takes about
8minutes for the boiler to reach the optimum
GB
21