Steam - Ironing; Surge Of Steam - Fakir SkyJET Instructions Manual

GB

Steam - Ironing

When steam ironing, ensure that the water tank is at least 1/4 full of water.
IMPORTANT!
Your iron has a dry tank alert light , this will illuminate if
the tank is nearly empty and needs
refilling. Always check that the water tank has an
adequate amount of water in it to ensure optimum
steam production. As per the indications on the
temperature dial and the table A (see section " Setting
the temperature" ) that steam-ironing is only possible at
higher ironing temperatures, indicated with •• or •••.
The drip stop system will automatically stop the iron from
steaming if the selected temperature is too low.
• Plug into the mains supply and switch on.
• Set the temperature dial at the required position within the
steam area ( •• or •••) and wait until the heating indicator
light has gone out (Figure 3).
• Set the steam selector to the required setting. You can then
begin steam ironing.

Surge of Steam

The Surge of Steam provides an extra burst of steam which
is ideal for removal of stuborn creases and wrinkles during
STEAM or DRY ironing.
• The Surge of Steam function can only be used at
temperature settings between ••• or LINEN.
• Lift the iron slightly above the surface of the fabric, press
the Surge of Steam button down firmly and then release it
during ironing (Figure 4). An intense ' burst' of steam
penetrates deep into the fabric.
For optimum steam quality, leave an interval of at least four
seconds between pressing the Surge of Steam button.
SkyJET
26
Fig. 3
Fig. 4