Installation Of The Panel; Mains Connection - Kemppi MasterTig MLS 2500 Operation Instructions Manual

1
Torch

2.5. INSTALLATION OF THE PANEL

1.
1. Fasten the cable connectors of the function panel to the power source (2 pieces).
2. Place the bottom edge of the panel behind the securing clips on the machine. Then gently
push the upper part of the panel into place. Make sure that the cables do not get damaged, conti-
nue gently pushing the upper part of the panel until it clips into place.

2.6. MAINS CONNECTION

Only an authorised electrician is allowed to install mains cable and plug!
The power source is equipped with a 5-meter mains cable without plug. The plug may be instal-
led by an authorised electrician only. The fuse and cable sizes are given in the Technical data at
the end of this manual.
©
COPYRIGHT KEMPPI OY
Installing gas-cooled
torch
2.
Master(tig) 2500, 2503, 3500, 3503 MLS™/ 0311 – 5
Rear of machine
1. Mains switch
2
2. Snap connector for gas
Installing water-cooled torch