Table of Contents
Advertisement
OPERATOR ACTION/COMMENTS
Enter DRT number of disc controller.
Enter 1
Enter a unit number 0 through 7. Set Unit Select
Switch on disc drive to the same number. Press
RUN on the System Control Panel.
Question is repeated until you test eight numbers.
Then testing continues.
Respond with a logical unit number, 0 through 7.
Type a one (1) to initialize the pack.
Type a one (1) to check the disc pack for surface
damage.
Type a zero (0) for a short pass.
Type a one (1) for a long pass.
HP 30310A Power Supply
CONSOLE MESSAGES/COMMENTS
UNIT SELECT SWITCH TEST?
(0=N,1=Y)
ENTER UNIT #, SET SWITCH TO UNIT #
ENTERED, PRESS RUN
ENTER UNIT #, SET SWITCH TO UNIT #
ENTERED, PRESS RUN.
ENTER UNIT # TO BE TESTED
FORMAT PACK? (O=N, 1=Y)
VERIFY PACK? (O=N, 1=Y)
VERIFY LONG PASS? (O=N, 1=Y)
BEGIN FORMAT
END FORMAT
BEGIN VERIFY
VERIFY PASS #1
VERIFY PASS #2
VERIFY PASS #3
END VERIFY
(Takes about 10 minutes)
(For short and long pass;
takes about 7 minutes.)
(For long pass only; takes
about 14 minutes.)
BEGIN MAIN
END HEAD TEST
END TRACK SWITCH TEST
ENDW/RTEST
(Main tests require
about 5 minutes.)
Type RUN to repeat SLEUTH07 execution or halt
the system.
JAN 1977
1-29
>670
(a typical prompt for input)
Advertisement
Table of Contents
