HP 3000 SERIES II System Service Manual page 27

System Verification
OPERATOR ACTION/COMMENTS
CONSOLE MESSAGE
D340 ERROR RESPONSE TEST
D367 ERROR RESPONSE TEST COMPLETED
D600 SELECTOR CHANNEL DIAG COMPLETED
D60l END OF PASS 1
Program restarts and continues to run until operator presses
HALT.
1-22.
HP 30012A EXTENDED INSTRUCTION SET DIAGNOSTIC (D431)
The extended instruction set diagnostic is contained in two sections. Section 1 is the Floating Point
diagnostic and Section 2 is the Decimal diagnostic. The diagnostic is designed to verify that both
Floating Point and Decimal instructions execute properly, and any residues derived are verified for
correctness. The following procedure is used to verify operation.
OPERATOR ACTION/COMMENTS
Cold load diagnostic D43l from stand-alone diagnostic tape.
Press RETURN
x
=
Version
YY
=
Update level
ZZ
=
Fix level
Set SYSTEM SWITCH REGISTER bit 0 off.
Press RUN
Set SYSTEM SWITCH REGISTER bit 0 off.
Press RUN
Program execute and displays the following message.
(Execution time for 200 passes is approximately 60 seconds.)
Program halts after 200 passes.
CONSOLE MESSAGES
DOl HP 30012A EXTENDED INSTRUCTION SET DIAG-
NOSTIC (D431.X.YY.ZZ)
QOl ENTER SWREG.SELECT OPTIONS
Q02 ENTER SECTION SELECT OPTIONS
D02 200 PASSES COMPLETED
1-23. HP 30115A NINE-TRACK MAGNETIC TAPE DIAGNOSTIC (D433)
The diagnostic verifies the input, output, and control functions of the HP 30115A nine-track magnetic
tape unit. A blank reel of tape (80 - 100 feet) with a write ring must be available for test purposes. The
following procedure is used to verify operation.
OPERATOR ACTION/COMMENTS
Cold load diagnostic D433 from st~nd-alone diagnostic tape.
Press RETURN
X
=
Version
YY
=
Update level
Z
=
Fix level
Enter in decimal the DRT number of the tape controller.
Press RETURN
CONSOLE MESSAGES
HP 30115A 9-TRACK MAGNETIC TAPE (D433X.YY.Z)
(STAND-ALONE DIAGNOSTIC PROGRAM) .
QOlO TAPE DEVICE NUMBER?
QOll TIMER DEVICE NUMBER?
1-17