HP 3000 SERIES II System Service Manual page 37

System Verification
7. The following message appears on the terminal.
<CONTROL Y>
4 RECORDS PROCESSED ***0 ERRORS
8. Terminate FCOPY by entering the following:
>EXIT
9. Compare the tape just produced with figure 1-4, the two tapes should be identical.
If
the tapes
differ, use SLEUTH to determine the problem with the paper tape punch.
r.
PACKARD •••••••
A.l:i2 n
+ttIW4..«.Jt.,IACKARD ••
it rrA~
I-II='WLETT.
•••••••••• 'f
~ ~.......... ~~.~~.
••••••••••• ••••••••••••••
•••••
•
••••
•••••••• ••• ••
••••• ••••••••••• •
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
••••
•
•••• •••• ••••
•
•••• ••• ••••••
•
•• •• ••••
••
•• •• •• •• ••••••• •••• •• ••• •
• • • •
• •• •
•
•
• • • • • • • • •
•
••
•
• • • ••• •• • •••
Figure 1-4. Master Tape
1-31. PAPER TAPE READER VERIFICATION. To verify operation of the paper tape
reader, perform the following steps:
1. Log onto the system.
:HELLO FIELD.SUPPORT,HP32230
2. Set up the reader file command, where LDN = the logical device name of the paper tape reader.
:FILE IN;DEV= LDN;REC= -72,I,F,ASCII
3. If the reader is a job accepting device, the follC'wing entries are required at the system console to
make the reader non-job accepting.
=REFUSE LDN
= ABORTIO LDN
4. Use FCOPY to read from the tape reader and write to the terminal.
:RUN FCOPY.PUB.SYS
HP32212A.XX.YY FILE COPIER (C) HEWLETT-PACKARD CO. 1976
>FROM=IN;TO=
5. Place the paper tape (30204-80003) supplied with the reader into the read head leaving some
leader behind the read head.
6. Answer the 110 request on the system console with the PIN and logical device number of the tape
reader.
1-27