Spout Installation; Reboarding Step Installation (Vxr) - Yamaha Waverunner VXS VX1800 Service Manual

Spout installation

1. Install the spout "1", and then tighten the
spout nut "2" to the specified torque.
2. Connect the hose "3", and then tighten the
spout hose clamp "4" to the specified
torque.
TIP:
Face the mark "a" toward the BOW.
a
BOW
Spout nut "2"
5.5 Nm (0.55 kgf·m, 4.06 ft·lb)
Spout hose clamp "4"
2.5 Nm (0.25 kgf·m, 1.84 ft·lb)

Reboarding step installation (VXR)

1. Secure the brackets on both sides of the
reboarding step in the down position using
the plastic ties "1" so that they will not re-
turn to the up position.
2. Install the reboarding step "1", and then
tighten the reboarding step bolts "2" to the
specified torque.
1
2
4
3
1 1
2
2
1
Reboarding step bolt "2"
16 Nm (1.6 kgf·m, 11.8 ft·lb)
3. Remove the plastic ties. Check that the re-
boarding step returns properly.
8-33
Rear section
LT
271
2
2
LT
271