Yamaha Waverunner VXS VX1800 Service Manual page 105

1
2
29. Fasten the wire harness using the plastic
ties "1".
1
30. Connect the fuel pump module coupler "a".
a
31. Fasten the wire harness using the plastic
ties "1".
32. Connect the sensor and switch couplers
"a". See "Coupler layout" (2-17).
1
1
1
1
33. Connect the remote control receiver cou-
pler "a", and then fasten the wire harness
using the plastic tie "1".
34. Install the antenna holders "2".
2
35. Install the air filter case "1", and then tight-
1
en the air filter case bolts "2" to the speci-
fied torque.
36. Install the air filter, air filter case cover "3",
and air intake pipe "4", and then tighten the
air intake pipe clamps "5" to the specified
torque.
37. Install the breather hose "6", and then fas-
ten it using the clamp "7".
2
Air filter case bolt "2"
13 Nm (1.3 kgf·m, 9.6 ft·lb)
Air intake pipe clamp "5"
3.5 Nm (0.35 kgf·m, 2.58 ft·lb)
38. Connect the quick connector "1" to the fuel
rail, and then install the plastic tie "3".
39. Install the oil level gauge "2".
a
5-14
2
3
1
2
6
5
Engine mount
a
1
7
4
5