Exhaust System Installation - Yamaha Waverunner VXS VX1800 Service Manual

Exhaust system installation

1. Install the plate "1" onto the rubber hose
"2".
TIP:
Make sure to fit the projections "a" on the rub-
ber hose "2" with the grooves in the plate "1".
2
a
1
2. Install the rubber hose "1" and a new ex-
haust valve "2", and then tighten the nuts
"3" to the specified torque.
Do not reuse a exhaust valve, always re-
place it with a new one.
Rubber hose nut "3"
5.5 Nm (0.55 kgf·m, 4.06 ft·lb)
3. Install the water tank "1", and then tighten
the clamp "2" to the specified torque.
TIP:
Align the alignment mark "a" on the rubber
hose "3" with the alignment mark "b" on the wa-
ter tank "1".
a
1
2
3
8-24
3
a
Rubber hose clamp "2"
3.5 Nm (0.35 kgf·m, 2.58 ft·lb)
4. Install the water lock and rubber hose "1",
and then tighten the clamp "2" to the spec-
ified torque.
TIP:
Align the projection "a" on the rubber hose "1"
with the alignment mark "b" on the water tank.
1
2
Rubber hose clamp "2"
3.5 Nm (0.35 kgf·m, 2.58 ft·lb)
5. Install the resonator "1", and then tighten
the clamp "2" to the specified torque.
TIP:
Fit the protrusion "a" on the resonator "1" be-
tween the protrusions "b" on the rubber hose.
a
Exhaust system
2
1
b
a
b
b
2
1