Valve Seat Check - Yamaha Waverunner VXS VX1800 Service Manual

Valve guide remover/installer "1"
90890-06801
Valve guide remover "1"
YB-06801
Valve guide installer "2"
90890-06810
Valve guide installer "2"
YB-06810
Valve guide installation height
12.3–12.7 mm (0.48–0.50 in)
3. Insert the special service tool "1" into the
valve guide "2", and then ream the valve
guide "2".
TIP:
• Turn the special service tool "1" clockwise to
ream the valve guide "2".
• Do not turn the special service tool "1" coun-
terclockwise when removing the tool.
Valve guide reamer "1"
90890-06804
Valve guide reamer "1"
YM-01196
4. Clean the valve guide inner surface. Mea-
sure the valve guide inside diameter "a".
a

Valve seat check

1. Remove carbon deposits from the valves
2. Apply a thin, even layer of blue layout fluid
3. Press the valve lightly against the valve
1
2
4. Measure the valve seat contact width "a"
5-50
Valve and valve spring
Inside diameter-intake
5.504–5.522 mm (0.2167–0.2174 in)
Inside diameter-exhaust
5.504–5.522 mm (0.2167–0.2174 in)
and valve seats.
(Dykem) onto the valve seat.
seat using the special service tool "1".
1
Valve lapper "1"
90890-04101
Valve lapping tool "1"
YM-A8998
where the blueing dye is adhered to the
valve face. Reface the valve seat if the
valve is not seated properly or if the valve
seat contact width "a" is out of specifica-
tion. Replace the valve guide if the valve
seat contact width "a" is uneven.
a