Normal Measurement - AND UM-211 Instruction Manual

THIS SIDE TO PATIENT Means the symbol for the patient side.

Normal Measurement

1. Place the cuff on the arm.
Sit quietly during measurement.
2. Press the START/STOP button.
All of the display segments are displayed.
Zero (0) is displayed blinking briefly.
The display changes, as indicated in the
figure at the right, as the measurement
begins. The cuff starts to inflate. It is normal
for the cuff to feel very tight.
Note: If you wish to stop inflation at any time,
press
again.
3. When inflation is complete, deflation starts
automatically and
indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not obtained, the
device starts to inflate again automatically.
To
"Measurement
Pressure" on the next page.
4. When the measurement is complete, the
systolic and diastolic pressure readings
and pulse rate are displayed.
The cuff exhausts the remaining air and
deflates completely.
5. Press the START/STOP button to carry out
the measurement again.
The device will proceed to standby
mode automatically when no operation
is made for a regular time.
RANGE symbol
The index symbol with the cuff should be in a range of this symbol.
Means the symbol for suggestions on operation.
the START/STOP
(heart mark) blinks,
avoid re-inflation,
with
All of the display
segments displayed
button
see
the SET
Systolic pressure
Diastolic pressure
English 22
At heart level
Press
Zero display
Starts inflation
Pressurizing
Measurement
in progress
Pulse rate
Exhausts remaining
air automatically
START
STOP