Table of Contents
Advertisement
3
OSD -
FUNCTION SETUP > PRESET SETUP
1
FUNCTION SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
<PRESET SETUP>
<SCAN SETUP>
<PATTERN SETUP>
<GROUP SETUP>
<SCHEDULE SETUP>
BACK
EXIT
2
PRESET SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
PRESET NO.
UNDEFINED
<EDIT SCENE>
BACK
EXIT
3
EDIT SCENE
- - - - - - - - - - - - - - - - - - - - - - - - - - -
MOVE TO TARGET POSITION
[NEAR:SELECT/FAR:CANCEL]
4
PRESET SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
PRESET NO.
<EDIT SCENE>
<LABEL>
CLR PRESET
CANCEL
CAM ADJUST
GENERAL
ALARM OUT
- - - -
BACK
EXIT
Press Near/Enter Key
1
Select <EDIT SCENE>,
Press Near/Enter Key
-PRESET1
0/0/x1/E
Press Near/Enter Key
1
FUNCTION SETUP
1
Configure 5 special functions with this menu.
2
PRESET SETUP - Undefined
127 presets from the number 1 to 128 can be assigned excluding
preset 95 reserved for menu.
PRESET NO.
1 ~ 128 (Excluding 95)
If a selected preset is already defined, camera moves to pre-defined
position and preset characteristics such as label and relay outputs show
on monitor. (Refer screen 4) If a selected preset is not defined,
'UNDEFINED' shows on monitor.
<EDIT SCENE>
Redefine the current preset scene position(i.e. PTZ).
EDIT SCENE
3
1. Using joystick, move camera to the desired position.
2. By pressing near key, save the current PTZ data.
3. Press far key to cancel.
PRESET configuration should be used only for Optical Zoom,
if optical zoom and digital zoom are used together and
PRESET is set, it is likely to cause malfunction.
4
PRESET SETUP
If the preset is defined, the information will be shown on the
OSD menu with the setting, and the alarm device (if defined)
will be activated.
PRESET NO.
1 ~ 128 (Excluding 95)
<EDIT SCENE>
<LABEL>
Edits Label to show on monitor when preset runs. Max. 10 alphabets
are allowed.
CAM ADJUST
GENERAL / SPECIAL
- WB(White Balance) and AE(Auto Exposure) can be set up independently
for each preset.
- GENERAL: WB or AE can be set up totally and simultaneously for all
presets in 'ROOT MENU>CAMERA SETUP' menu.
- SPECIAL: WB or AE can be set up independently or separately for each
preset in each preset setup menu.
- Each special WB/AE value should the activated correspondingly when
camera arrives at each preset location. During jog operation, general
WB/AE value should be applied.
- All special WB/AE value should not be changed although general
WB/AE value is changed. If 'SPECIAL' is selected, the menu to set WB/AE
is shown on monitor.
- - - - ~ 1 2 3 4
ALARM OUT
State of four alarm outputs can be freely controlled in conjunction
with preset run. The character ' - ' means off state and the number
representing each bit means on.
Ex) If it is set to be ' - 2 3 - ', output relay 2, 3 will be on and 1, 4 will be
be off, when you run this preset.
25
Advertisement
Table of Contents
